Medtronic Revel Podręcznik Użytkownika Pobierz pdf (Strona 29)

Tubing Connector

If insulin, or any liquid, gets inside the tubing connector, it can temporarily block the vents that allow the

pump to properly prime the infusion set. This may result in the delivery of too little or too much insulin,

which can cause hypoglycemia or hyperglycemia. To prevent liquid from getting inside the tubing

connector, after you fill the reservoir make sure you hold the insulin vial upright when you remove the

reservoir from the transfer guard. If you do not hold the insulin vial upright, insulin can get on the top of

the reservoir and could transfer liquid into the tubing connector. If any liquid gets on the top of the

reservoir or inside the tubing connector when you change your infusion set, start over with a new reservoir

and infusion set. For instructions on setting up your reservoir, see Setting up the reservoir, on page 52.

For instructions on changing your infusion set, see Changing your infusion set, on page 54.

Tubing

connector

Top of

reservoir

Magnetic fields

Do not use pump cases that have a magnetic clasp.

Do not expose your insulin pump to MRI equipment or other devices that generate very strong magnetic

fields. The magnetic fields in the immediate vicinity of these devices can damage the part of the pump’s

motor that regulates insulin delivery, possibly resulting in over-delivery and severe hypoglycemia.

Your pump must be removed and kept outside the room during magnetic resonance imaging (MRI)

procedures.

If your pump is inadvertently exposed to a strong magnetic field, discontinue use and contact our 24 Hour

HelpLine for further assistance.

Introduction8

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 264 265

Brak uwag

Medtronic Revel Podręcznik Użytkownika Strona 29