Medtronic Paradigm 522 Podręcznik Użytkownika Pobierz pdf (Strona 47)

Install battery

CAUTION: Do not use a rechargeable or carbon zinc battery in your pump. For best results use a new

Energizer AAA alk

aline battery, size E92, type LR03.

Medtronic Diabetes designed the pump to only accept a new battery. As a safety measure, if you install a

battery that does not have full power

, the WEAK BATTERY or FAILED BATT TEST alarm may sound. If you

receive a WEAK BATTERY alarm, respond to the alarm and continue. The pump will still operate normally,

but with a decreased battery life. The pump uses one AAA alkaline battery.

1 Make sure all the following apply:

• Clear (ESC, ACT) any alarms and/or alerts before removing and replacing the battery.

• Make sure the pump is at the HOME (idle) screen when you remove the battery.

• Do NOT remove the battery during a bolus or prime delivery.

2 Use the edge of a coin to remove the battery cap. Turn the cap in a counter-clockwise direction.

3 Remove the old battery and dispose of it per

the disposable requirements of your state or

country. Put the new battery in the pump with

the negative end [(-) symbol] going in first.

Check the label on the back of the pump to

make sure the battery is inserted correctly.

NOTE: Do not use batteries that have been in

cold storage, such as in the refrigerator or in your car during winter in cold climates.

4 Place the battery cap in the pump and tighten so the slot is aligned

horizontally with the pump as shown here:

CAUTION: Do NOT over-tighten the battery cap. You should not turn

the cap more than four half turns. If you over-tighten the cap you

may not be able to remove it, and you can damage your pump.

battery cap

battery

one half-turn

The basics28

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 261 262

Brak uwag

Medtronic Paradigm 522 Podręcznik Użytkownika Strona 47